Logitek-electronic-systems Mosaic Manuel d'utilisateur télécharger pdf (Page 36)

Logitek Mosaic Reference Manual

Page 36

Monitor Module

The monitor module controls all monitoring functions:

GUEST/STUDIO section:

GUEST/STUDIO section:GUEST/STUDIO section:

GUEST/STUDIO section:

TB button: inserts the Talkback Mic (as defined in JetSet/AE Config Surface

Settings) into the Guest/Studio monitor bus

FOL MON: When turned on, the route to GUEST/STUDIO will follow

routing changes to the MONITOR section.

MUTE: mutes the Guest/Studio monitor bus.

To change the route, press on the Guest/Studio knob. The knob will turn

green and the take light will light up. Turn the knob until you see what you

would like to listen to. Press Take to accept. To cancel, press the

Guest/Studio knob again. It will exit the mode and turn blue. If FOLLOW

MONITOR is engaged, changing the route with the knob will turn

FOLLOW MONITOR off.

When the knob is blue, it controls the volume.

SEL1 – SEL4 buttons: when pressed, these will change the route to the

Guest/Studio monitor bus if they were programmed via Command Builder

as described in the previous chapter.

HEADPHONE

HEADPHONEHEADPHONE

HEADPHONE

section:

section: section:

section:

MONO: sets the headphones to mono

FOL MON: When turned on, the route to the headphones will follow

routing changes to the MONITOR section.

SPLIT: Sends the bus being monitored to the left and cue to the right.

To change the route, press on the Headphone knob. The knob will turn

green and the take light will light up. Turn the knob until you see what you

would like to listen to. Press Take to accept. To cancel, press the

Headphone knob again. It will exit the mode and turn blue. If FOLLOW

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 42 43 44

Pas de commentaire

Logitek-electronic-systems Mosaic Manuel d'utilisateur Page 36